Heat pumps
AC repair
Furnace & heating
Ductless mini splits
Carrier
Trane
GoodmanSeasonal tune-up and full diagnostic on your Carrier, Trane, or Goodman system - readings shown to you before any repair is proposed
Diagnosis first, numbers second - you approve the repair price before a single part goes in.
Get your free estimateLennox Heat Pump Service: The Mesquite Owner’s Guide
When a Lennox heat pump needs service, most Mesquite homeowners pay between $150 and $650 for the repair, and we can often have a technician at your door the same day you call. The part that fails most often in this climate is the capacitor, followed by contactors, reversing valves and defrost boards. You usually find out the hard way: the house stops cooling on a 110-degree afternoon, the outdoor fan runs but the compressor won’t kick on, or the system blows lukewarm air in heating mode. If any of that sounds familiar, call (888) 570-3601. A live person answers, day or night, and we’ll get you a straight answer fast.

We service Lennox heat pumps across Mesquite, and we know these systems well enough to skip the guesswork. Our technicians have up to 8 years of experience and are trained on nine major brands, including Carrier and Trane. Fireside Heating & Air Co. Mesquite is an independent service provider, not affiliated with Lennox.
Which Lennox Models This Applies To
Our work covers the Lennox heat pump families common in Mesquite homes: the Merit series (13HPX, 14HPX), the Elite series (XP14, XP16, XP17), and the Dave Lennox Signature Collection (XP21, XP25). Each series uses different control boards, defrost logic and valve designs, so the model number matters. You’ll find it on the data plate on the outdoor unit’s side or back panel, usually a string like “XP16-048-230.” Write that down before you call. It tells us exactly which capacitor, contactor or board we’re sourcing before we ever leave the shop.
Here’s where Lennox is different from most brands: the OEM parts carry specific ratings tied to that series. A 45/5 MFD dual-run capacitor from a Merit unit won’t work in a Signature unit that calls for 70/7.5. And some Signature models use communicating boards that won’t accept a generic aftermarket replacement without throwing a fault code. On the OEM-versus-aftermarket question, we’ll tell you honestly. Where a quality aftermarket equivalent meets the same specs and saves you real money, we’ll say so. Where the original Lennox part is the only safe match, we’ll say that too. No upselling either way.
Styles & brands we work with
- AC repair
- Furnace & heating
- Heat pumps
- Ductless mini splits
- Carrier
- Trane
- Goodman
Signs Your Lennox Heat Pump Service Is Failing
These are the symptoms Mesquite homeowners describe when they call us, and what’s usually behind each one:
- The outdoor fan spins but the compressor stays silent. This is almost always a failed run capacitor or a tripped contactor. In Mesquite’s summer heat, capacitors run hot and fail faster here than in cooler climates.
- The system won’t switch to heating. A stuck reversing valve or a bad defrost control board keeps the unit in cooling mode. You’ll feel cold air when you asked for heat.
- Ice builds up on the outdoor coil and won’t clear. A failing defrost sensor or board stops the periodic defrost cycle. Left alone, the ice stresses the compressor.
- Lukewarm air in heating, weak cooling in summer. Low refrigerant or a compressor contactor that’s pitting and arcing. Both show up slowly, so the decline can be easy to miss.
- Breaker trips when the unit starts. A shorted compressor or a failing capacitor drawing too much current. Stop resetting the breaker and call. This one is a genuine electrical hazard.
A hard truth worth stating plainly: a capacitor that costs a few dollars wholesale is the single most common failure we see in Mesquite heat pumps, and it takes down the whole system when it goes. That’s not a design flaw. It’s just how these parts age in desert heat.
See the difference
Before
After
Before
After
Before
AfterReplacement Cost & What’s Included
Heat pump repair in Mesquite typically runs $150 to $650, and that range covers what our customers actually pay. Here’s what drives it:
- Capacitor or contactor swap: at the low end of the range, and usually done in one visit.
- Defrost board or reversing valve: toward the middle to upper end, because the part itself costs more and the job takes longer.
- Compressor or major component: the high end or above, depending on the model and parts availability.
The price we quote is the price you pay. No surprise line items, no overtime charge for nights or weekends, and no-hassle upfront pricing on every job. Every repair carries the 90-Day Done Right Promise, in writing: if it isn’t right, we make it right. Right now we’re also running $50 off any repair over $250 and a free second opinion on any written estimate. If you’re 65 or older, or a veteran, there’s a standing 5% discount on top.
DIY or Call Us?
Some things you can check safely. Confirm the outdoor unit has power at the disconnect. Look at the air filter and swap it if it’s clogged. Note the model number from the data plate and whether the fan runs or the compressor is silent. That’s useful information to give us when you call.
What you shouldn’t do is open the electrical panel on the outdoor unit or handle capacitors yourself. A heat pump capacitor holds a dangerous charge even after the power is off, and the 240-volt circuit feeding that unit can hurt or kill you. Reversing valves and compressor work are no place for a homeowner either. We’d rather you call than take that risk. Dial (888) 570-3601 and we’ll send a background-checked, uniformed technician who puts on shoe covers without being asked.
FAQs
Expect five to ten years from a capacitor in most climates, but Mesquite’s summers push that toward the shorter end. The constant heat cycling and 100-plus-degree afternoons age these parts faster than anywhere cooler. When one fails, we replace it with a part rated for the same temperature and voltage specs.
Sometimes, yes. A contactor with pitted points can occasionally be cleaned and reused, but a capacitor that’s bulging or leaking can’t be repaired, only replaced. A reversing valve that’s stuck can sometimes be freed, but a failed defrost board has to go. We’ll tell you honestly which category your part falls into, and we won’t replace something that’s still serviceable. Call (888) 570-3601 for a free second opinion if another company has quoted you a replacement.
Most single-part repairs, like a capacitor or contactor, take under an hour once we’re on site, and we finish most jobs in a single visit. Board replacements and valve work run longer, but we don’t leave until it’s running right and you’ve seen it working.
We order the exact Lennox-spec part for your model number from a supplier, not a generic substitute that happens to fit. For common parts we can often get same-day availability in the Mesquite area. For less common Signature-series components, we’ll give you a clear timeline before we start so there are no surprises.
Whatever your Lennox heat pump is doing, the fastest path to a fix is a phone call. Dial (888) 570-3601 for a free estimate. A live person answers around the clock, the price we quote is the price you pay, and the work is backed in writing for 90 days. Done right, or we make it right.
Written by the team at Fireside Heating & Air Co. Mesquite, serving Mesquite and nearby areas.